RADIUMAUTO FST installation kit for port injection for Ford Focus EcoBoost

-

This comprehensive kit contains everything needed to install a radium fuel pressure tank with dual 39mm fuel pumps on a 2013+ Focus ST and 2015+ Focus RS.

This system uses 2 fuel pumps in the expansion tank. Each pump runs in a separate independent fuel system. A pump is used to replace and imitate the OEM fuel supply line and supply the OEM HPFP. The other pump is used to supply fuel to an aftermarket ported (secondary injection) fuel rail. Both pumps are protected from fuel starvation as the OEM low pressure fuel pump(s) are diverted to fuel the FST. The spilled fuel drains back into the OEM fuel filler hose using an included billet adapter.

The new FST pump powering the OEM HPFP is regulated with a non-adjustable Radium FPR. This can be vacuum referenced when 1:1 fuel pressure is required or ran static to mimic the stock system. The new FST pump, which feeds the separate injection system, directs the fuel through a 6 micron Radium micro glass filter. To regulate port injection fuel, a black Radium Engineering direct mount regulator with an 8AN ORB inlet is included.

The MK3 Ford Focus Installation Kit places the FST in a collision safe area under the vehicle, in front of the rear bumper beam. The anodized aluminum bracket mounts securely to the OEM mounting points. Heat tape is included to reflect unwanted heat from the exhaust system as shown above.

Also included are wiring components using flying leads with Raychem solderless butt splices, as well as weatherproof fuses and relays to drive the FST fuel pumps. Wiring is very easy and takes less than 30 minutes. Soldering is not required.

What's included?
-Black DMR fuel pressure regulator, 8AN ORB
-Fuel pressure regulator, not adjustable, Bosch Top
-6 micron microglass fuel filter with heat exchanger
-Aluminum MK3 Focus FST mounting bracket
-Silicone filled fuel pressure gauge
-Aluminum Push-Lok -6AN hose fittings
-AN and OEM adapter connectors
-Vapor shield 3/8" (-6AN) EFI hose
-Wiring components with relay and fuse
-Stainless steel hardware

What is required?
1. Standard dual pump fuel overflow tank
2. Port Injection Kit and Fuel Injectors